Xerox Phaser 790 Documentation

21. Performing the setup from WebSetup
Xerox Phaser 790
21–5
Server Setup
In Server Setup, you can specify server settings; set, change or
remove server passwords; and specify job log page size and support
options.
1. Select the Server Setup button from the WebSetup screen to
display the Server Setup tabs.
Perform the following:
a. Specify a default Server Name. This is the name that
displays in the Chooser on an AppleTalk network.
Do not use the Device name (Phaser 790) as the server name. If you have
more than one server, be sure to assign them different names. Windows NT
4.0 does not support two computers with the same name in the same
workgroup or domain.
b. Select the Print Start Page check box to print a start page
each time the printer is restarted. The Start Page lists server
name, current date and time, amount of installed memory,
last calibration date, network protocols enabled, and print
connections published. To deselect the option, ensure there
is no check mark in the box (default).

Xerox Phaser 790 Specifications

General

Brand	Xerox
Model	Phaser 790
Category	Copier
Language	English