Xerox Phaser 790 Documentation

7. Performing the setup from the Printer Control Panel
Xerox Phaser 790
7–13
Bindery Setup
The following screens are used for Bindery setup. Ensure that the
printer is connected to the network and you have already configured
one or more NetWare 3.x file servers with a print server and a print
queue for print jobs.
You can also configure NetWare 4.x and 5.x servers to run in Bindery
emulation mode, but you cannot add a 4.x or 5.x server running in emulation
mode that is on the tree you selected in NS Setup.
The NetWare server must be running. You need a login name and a
password, if one has been set.
Refer to the chapter Setting up the network server for more information
about setting up printing using Novell NetWare.
1. Press the Offline button and press the Menu button until the
Enable Bindery option is displayed. Use this option to enable
bindery emulation services.
The Bindery Settings screens displays.
2. Use the up and down arrow buttons to scroll through the menu
options. Select one of the following options:
• View displays a list of Novell file servers already connected
to the printer.
• Change displays a list of all available servers in order to add
one or change the print server setting.
• Remove Fserver displays a list of connected servers that
you can disconnect.
• Skip disregards bindery options and advances to the Polling
Int screen.
Use the up and down arrow buttons to view the list of servers.
Press Item/Enter to skip the remaining options and advance to
the Polling Int screen.

Xerox Phaser 790 Specifications

General

Brand	Xerox
Model	Phaser 790
Category	Copier
Language	English