Xerox Phaser 790 Documentation

23. Problem Solving Network Problem Solving
23-38 Xerox Phaser 790
Network Protocol Setup messages
The following table lists the network protocol messages that you may be seen
during the Network Protocol setup. It also contains the last Setup screen
shown before the message appears, a description of the problem, and any
action required.
Message Setup screen Description and action
No AppleTalk zone
found.
Enable AppleTalk
(Network Protocol
Setup>
AppleTalk Setup)
• The Ethernet network cable
is not attached to the
connector on the Phaser 790
or the network cable is not
plugged into the hub or
network. If your AppleTalk
network has zones, and you
want to specify a zone for the
Printer, you must connect the
network cable to the Phaser
790 before performing
AppleTalk Setup.
• AppleTalk network does not
have zones. Zones are not
required for printing to the
Phaser 790. Press OK to
continue.
You must first
enable a network
port.
Protocol Setup or
Service Setup
(Network Setup)
Enable at least one network
port (Ethernet or Token Ring) in
Port Setup before beginning
Protocol Setup or Service
Setup.
Invalid frame size Frame Type selection
(Network Protocol
Setup>
IPX>SPX Setup)
The network hub is not
connected to a Novell server
when the Phaser 790 tries to
bind.
Warning IPX
network number is
zero.
Frame Type selection
(Network Protocol
Setup>
IPX>SPX Setup)
No other IPX computer can be
found on the network, or the
network hub is not connected
to the network when the Phaser
790 tries to bind. When this
occurs, the network number
defaults to zero.
Can’t detect Token
Ring hardware.
Frame Type selection
(Network Protocol
The Printer queries the Token
Ring hardware. Either some

Xerox Phaser 790 Specifications

General

Brand	Xerox
Model	Phaser 790
Category	Copier
Language	English