Xerox Phaser 790 Documentation

Network Problem Solving 23. Problem Solving
Xerox Phaser 790 23-39
Message Setup screen Description and action
Token Ring
Hardware not
installed or not
functioning.
Setup>
IPX>SPX Setup)
components are not installed,
are not installed correctly, or
are not installed in the correct
device. An unsupported Token
Ring board may be in use. Call
for support.
Can’t autodetect the
ring speed. No
device on ring.
Token Ring Setup The Printer is trying to detect
the current ring speed, but it is
the only machine on the Token
Ring network. Connect another
machine to the Token Ring
network before connecting the
Phaser 790.
No NDS trees found. Enable NDS
(Network
Setup>Service
Setup>PServer
Setup>NDS Setup)
No NDS trees were found on
the Novell network. Ensure that
the frame types on the Printer
are properly configured.
Warning! Selecting a
new NDS tree
deletes Bindery
setup.
Select NDS Tree
(Network
Setup>Service
Setup>PServer
Setup>NDS Setup)
You have previously connected
the Phaser 790 to a different
NDS tree. NetWise supports
only a single NDS tree
connection. To avoid a
potential conflict with the
existing tree connection, all
bindery settings will be deleted.
When the message Delete
Bindery setup and continue?
appears:
• Select OK and Yes to delete
the current bindery settings.
Reenter the settings in
Bindery Setup.
• Press the Menu key or select
OK and No when the
message appears to avoid
deleting the bindery settings.
Continued…
Repeat NDS Setup without
changing the NDS Tree, or exit
to Bindery Setup to review the
current bindery settings.

Xerox Phaser 790 Specifications

General

Brand	Xerox
Model	Phaser 790
Category	Copier
Language	English