Xerox Phaser 790

Adding memory to the Printer 1. Setting up the Phaser 790
Xerox Phaser 790 1-49
Adding memory to the Printer
You will need a phillips head screwdriver to perform this procedure.
CAUTION
• Protect the memory card from static electricity by keeping it in the anti-
static bag until you are ready to install it.
• Handle the card by the top or side edges only. Do not touch the card
components or the brass connector edge.
• Avoid placing the card near magnetic devices, such as a pc monitor.
• Avoid exposing the card to direct sunlight, high temperatures, or
humidity.
1. Switch OFF the power to the Printer.
0
301073A-WOL
2. Disconnect the power cord from the rear of the Printer.
3. Remove the three screws from the upper right-hand side panel of the
Printer.
301083