Xerox Phaser 790 Documentation

8. Setting up the network server
Xerox Phaser 790
8–9
Configuring a Windows NT 4.0 server
Use the following procedure to configure a Windows NT 4.0 server to
communicate with the Phaser 790. Basic steps include:
• Load the TCP/IP network protocol and configure it with an IP
address, Subnet Mask, and Gateway.
• Enter the host name of the Phaser 790 in the host database
• Perform Printer Setup.
• On the Windows NT 4.0 server, create a printer for each print
connection, install the appropriate printer drivers, and (optionally)
share the printer on the network.
• Enter the host name and remote printer name of the Phaser 790
in the printer connection.
• If the Windows NT 4.0 server is also a workstation, install the
Fiery utilities.
More detail is provided in subsequent chapters and in your Microsoft
documentation.
Adding the Phaser 790 to the TCP/IP network
(Windows NT 4.0)
If your TCP/IP network consists of Windows NT 4.0 servers and
Windows NT 4.0 clients, perform the following procedure.
1. Register the IP address of the printer in the host name database
used by your system.
For installations that do not have a system administrator or a
central host name database, add the printer to the hosts file on
the Windows NT 4.0 server.
Add the printer to the hosts file on any workstations that have
TCP/IP loaded and will use the Fiery utilities.

Xerox Phaser 790 Specifications

General

Brand	Xerox
Model	Phaser 790
Category	Copier
Language	English