16. Introduction to the Command WorkStation
Xerox Phaser 790
16–24
Job commands
Job commands are used to assign a selected job to a new destination
or process. These commands are available from the Job menu. Many
are also available as right-mouse commands (described following the
list of commands below). The job commands available at a given time
depend on the context; unavailable commands are dimmed. Job
commands are available in the Queues and Archive windows.
How job commands affect raster data
The job commands available for selected jobs in the Queues and
Archive windows are listed in the following table. The table also
describes the effect of each command on raster data associated with
the job(s).
Select To do Raster data is…
Delete Delete the job(s). Deleted
Duplicate Duplicate one or more selected PostScript,
PCL, or PDF data jobs in the Spool or Print
areas. You can use the duplicate job(s) for
different print options or a different
destination. (The Duplicate command
actually creates a reference to the original
job, with the same name).
n/a
(The Duplicate command
is not available for raster
jobs.)
Rename Rename the job (PostScript, PCL, or PDF file
with or without raster).
Unaffected, but associated
with the new name
Hold Hold the job in the current place (except for a
job in the Print area, which is moved to the
Spool or RIP area, depending on whether it
still has raster data associated with it).
Held in RIP area, if
included with job
RIP and Hold RIP the job and hold it in the RIP area. Held in RIP area
indefinitely
Print Print the job in its turn (RIP it first if it does
not have raster data).
After printing, keep the printed job in the Print
area until the job limit is reached.
Temporarily held in RAM
after printing until memory
is needed for another job.
(If the job was printed from
a held job in the RIP area,
the raster data in the RIP
area is kept indefinitely.)
To Next Page
Loading...
Need help?
General
