Xerox Phaser 790 Documentation

16. Introduction to the Command WorkStation
Xerox Phaser 790
16–36
Job properties
When logged in as Operator or Administrator at the Command
WorkStation, use the Properties command to check and override the
print option settings (properties) of most jobs.
You cannot override the print option settings of PCL jobs.
You can use this command for several purposes:
• To check user job settings
• To override a setting based on printed output or other print device
conditions
• To change settings for a duplicate of the original job
• To print a single copy of a job before printing the number of
copies required by the user
Viewing and editing job properties
The Properties command lets you view, edit the print option settings of,
and print multiple jobs simultaneously. You can use this feature to
compare the properties of several jobs and thereby group together jobs
with similar settings, if it is beneficial for throughput or efficiency.
To view the properties of one or more jobs, select the job(s) and select
Properties from the Job menu or the right-mouse menu.
For information on using the Properties dialog box to change job
settings, refer to the section Viewing and overriding print settings in the
chapter Managing print jobs at the Command WorkStation.
Some print options that are available in the printer driver are not
displayed in the Properties dialog box. For information on specific print
options and settings, and where they can be set, refer to the chapter
Print options.

Xerox Phaser 790 Specifications

General

Brand	Xerox
Model	Phaser 790
Category	Copier
Language	English