Xerox Phaser 790

Printer Error Codes 23. Problem Solving
Xerox Phaser 790 23-35
Printer Error Codes
An error code may indicate that an electrical or mechanical problem exists in
the Printer. Typical error codes, six digit numbers with a hyphen in the
middle, are followed by the words CALL FOR SERVICE.
If an error code should appear on the Printer Control Panel perform the
following steps:
1. Write down the code number.
2. Switch OFF the Printer power switch.
3. Wait 20 seconds.
4. Switch ON the Printer power switch.
• If the problem is resolved, resume printing.
• If the problem is not resolved, call your service representative and
report the error code.