Printer installation 1. Setting up the Phaser 790
Xerox Phaser 790 1-25
Printer installation
Perform this procedure after the Printer is unpacked, and placed in a suitable
location.
• If you have not performed the Preparing for the installation procedure in
this section, do it now.
• If the Printer is still in the original packing, go to the Unpacking the
Printer procedure.
1. Locate the Output Tray in the cardboard tray removed from the top of
the printer. Install the tray by performing steps a through c.
a. Standing on the left-hand side of the Printer, hold the Output Tray
as shown.
Do not place the metal spring into the hole. Ensure that the metal spring
extends down against the outside of the cover.
b. Place the right-hand arm of the tray into the corresponding hole as
shown.
To Next Page
Loading...
Need help?
General
