Xerox Phaser 790 Documentation

Xerox Phaser 790
8–1
Setting up the network server
This chapter describes environments that typically include one or more
Novell NetWare and Windows NT 4.0 network servers that share
printing to the Phaser 790. It describes setting up servers that use
IPX/SPX or TCP/IP protocols for communicating with the printer.
The chapter includes guidelines for setting up direct communication
from Windows NT 4.0 and UNIX workstations, where a network server
is optional. It also outlines the requirements for network clients to print
to the Phaser 790 and to run the Fiery WebTools and utilities.
For specific Novell procedures, refer to your Novell documentation.
The Phaser 790 can accept jobs concurrently from NetWare, Windows
NT 4.0, and AppleShare servers, as well as jobs sent directly from
Windows NT or UNIX workstations. Because AppleShare servers
require no special configuration, they are not discussed in this section,
except for their use in the NT 4.0 Windows environment.
Support for Fiery utilities
The ColorWise Pro Tools and Command WorkStation Fiery utilities are
supported over the TCP/IP platform on Windows 95/98, Windows 2000
and Windows NT 4.0 platforms. More information is provided in later
chapters, according to network type.
8

Xerox Phaser 790 Specifications

General

Brand	Xerox
Model	Phaser 790
Category	Copier
Language	English