EasyManuals Logo

Xerox Phaser 790 Documentation

Xerox Phaser 790
542 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background imageLoading...
Page #85 background image
Xerox Phaser 790 3-1
Network Setup
The information in this chapter is for the customer only.
If you want to install the Print Drivers on their user workstation please go
to the appropriate procedure in this chapter:
• Windows 95/98
• Windows 2000
• Windows NT 4.0
• Macintosh OS 5.0
Installing the Token Ring Network card
The Token Ring Network Kit is required when setting up a closed loop, or
Local Area Network (LAN). Token Ring Networks can be connected to other
networks, in local and remote locations.
You will need a phillips screwdriver to perform this procedure.
CAUTION
• Protect the network card from static electricity by keeping it in the
antistatic bag until you are ready to install it.
• Handle the card by the top or side edges only. Do not touch the card
components or the brass connector edge.
• Avoid placing the card near magnetic devices, such as a PC monitor.
• Avoid exposing the card to direct sunlight, high temperatures, or
humidity.
1. Switch OFF the power to the Printer.
2. Disconnect the power cord from the rear of the Printer.
3

Table of Contents

Other manuals for Xerox Phaser 790

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox Phaser 790 and is the answer not in the manual?

Xerox Phaser 790 Specifications

General IconGeneral
BrandXerox
ModelPhaser 790
CategoryCopier
LanguageEnglish

Related product manuals