Xerox Phaser 790 Documentation

23. Problem Solving Network Problem Solving
23-56 Xerox Phaser 790
Message Corrective Action/Additional
Information
Functions menu.
Platen Scan in progress The Printer is completing a scan and
will be ready for printing in a few
minutes.
Print/Copy Cartrdg. misplaced The print/copy cartridge is not correctly
placed in the Printer. Check the
cartridge and reinstall it as necessary.
Print/Copy Cartrdg. type mismatched The print/copy cartridge installed is not
the correct cartridge. Remove the
cartridge and check your
documentation for specifications on the
correct cartridge to install.
Printing . . . This is a normal status message
indicating that printing is in progress.
Ready within 1 minute This is a normal status message. The
Printer is warming up. It will be ready
for printing in a minute.
Run setup and enter correct security
key
This message is displayed if your
model requires that you enter a
security code.
Trying to connect
Please wait . . .
An error may have occurred with the
Printer. Refer to the message panel for
information.
Turn power off
and on.
Switch off the Printer power, wait 20
seconds, and then switch on the
power.
Warming Up . . . This is a normal status message. The
print engine is powering up. It will be
ready for printing in a few minutes.

Xerox Phaser 790 Specifications

General

Brand	Xerox
Model	Phaser 790
Category	Copier
Language	English