Xerox Phaser 790 Documentation

Loading paper in the paper tray 1. Setting up the Phaser 790
Xerox Phaser 790 1-43
Moving the guides too tight against the paper stack can cause a jam.
7. Ensure that the vertical Paper Guide is aligned with the appropriate
paper size mark on the bottom of the tray.
Automatic paper size detection cannot occur if the vertical Paper Guide is
out of position.
8. Push the paper tray firmly into the Printer.
301065b
9. If there are additional paper trays installed in your Phaser 790, repeat
this procedure until all the trays are loaded with the desired paper stock.
The next step
Go to the next section Printing the Test Page.

Xerox Phaser 790 Specifications

General

Brand	Xerox
Model	Phaser 790
Category	Copier
Language	English