Xerox Phaser 790 Documentation

3. Network Setup Windows 95/98 print drivers
3-6 Xerox Phaser 790
7. Perform one of the following:
• If you are installing from the CD, browse to one of the following
folders:
• For PostScript printing: English\Prntdrvr\PS_drvr\Win_9x
• For PCL printing: English\Prntdrvr\PCL_drvr\Win_9x
• If you are installing from files you downloaded using the Installer
WebTool, browse to one of the following folders
? For PostScript printing: Prntdrvr\PS_drvr\Win_9x
? For PCL printing: Prntdrvr\PCL_drvr\Win_9x
Select OK and ensure that the oemsetup.inf or oemsetup option is
selected.
8. Verify the path is correct and select OK.
9. In the Printers box, select Xerox Phaser 790 and Next.
10. Select LPT1: ECP Printer Port and Next.
11. Using a maximum of 31 characters, enter a name for the printer or leave
the default name in the Printer name box.
12. If you want the Phaser 790 to be the default printer, select Yes; if not,
select No. Select Next.
13. Select No in the next dialog box to postpone printing a test page and
select Finish.
When the installation is complete, the necessary files are installed to your
hard disk. Configure the options on your printer and complete the appropriate
network connection.
For detailed information about setting up parallel port printing, IPX/SPX
printing, SMB printing or setting printer options and installing additional
software, refer to Installing the user software in a Windows 95/98
environment.

Xerox Phaser 790 Specifications

General

Brand	Xerox
Model	Phaser 790
Category	Copier
Language	English