Installation Overview — SH12 Shelf
Check Installation Procedure
Unpacking an SH12 Shelf
Inspecting the HD Equipment
Installing the Mounting Brackets on an SH12 Shelf
Installing or Removing Side Air Covers
Installing the Front Cover Extension
Connecting the Grounding Terminals
Mounting the SH12 Shelf to a Rack
Removing the SH12 Protection Plate
Installing the CEM
Installing the ECM
Installing the FTM-2 in the SH12
Installing the PSM-AC6 in the SH12
Installing the PSM-DC in the SH12
Installing a Traffic Module
Installing a QSFPPluggable Transceiver
Installing the Slot Covers
Connecting the Infrastructure Modules
Shortening and Assembling DCPower Cables
Connecting DC Power to the SH12 Shelf
Connecting ACPower to theSH12 Shelf
Inspecting and Cleaning Fiber-optic Connectors and Receptacles
Connecting the Optical Cables
Installing the SH12 Upper Front Cover
Installing the SH12 Lower Front Cover
For commissioning procedures, see the appropriate software document.
See Related Documents for the list of available documents.
l General Electrical Safety Guidelines and Warnings
l Installation Safety Guidelines and Warnings
l Electrical Safety Guidelines and Warnings
l Service Personnel Assumptions
FSP 3000R7 High-Density Subshelf Guide - R17.2 - Issue:B 236
To Next Page
Loading...
