Required Tools and Equipment
Chapter 36
Removing and Installing a Module Slot
Cover
Required Tools and Equipment 448
Removing a Module Slot Cover 448
Installing a Module Slot Cover 449
Required Tools and Equipment
l ESD-preventive wrist strap or other personal grounding device
l Appropriate slot cover
l Slot Covers
l HDEquipment General Safety Guidelines and Warnings
Removing a Module Slot Cover
1. Verify that you are properly grounded with an anti-static wrist strap or heel strap
connected to the grounded ESDjack.
2. If installed, remove the front cover from the shelf as described in Removing and
Installing Front Covers.
3. Loosen the thumb screws.
4. Grasp the thumb screws, and then carefully slide the slot cover out of the shelf.
l Electrostatic Discharge Damage Prevention and Warning
l General Installation and Maintenance Guidelines
l Operational Risks
FSP 3000R7 High-Density Subshelf Guide - R17.2 - Issue:B 448
To Next Page
Loading...