Adva 3000R7 - Required Tools and Equipment

Required Tools and Equipment
l Electrostatic Discharge Damage Prevention and Warning
l Installation Overview — SH12 Shelf
l Installation Overview — SH4R and SH4R-2 Shelves
l Installation Overview — SH1R Shelf
l Handling Equipment Precautions and Guidelines
Required Tools and Equipment
l ESD-preventive wrist strap or other personal grounding device
l SH12 infrastructure modules
o
CEM-2
o
ECM-2
o
Three FTM-2s
o
One to four PSM-DCs or PSM-AC6s (depending on your redundancy, load sharing
configuration)
l SH4R and SH4R-2 infrastructure modules
o
CEM-4
o
ECM-2
o
Two FTM-4s
o
One to three PSM-AC4s, PSM-AC5s, or PSM-DC4s (depending on your
redundancy, load sharing configuration)
l SH1R infrastructure modules
o
CEM-3
o
ECM-3
o
Three FTM-3s
o
One to two PSM-AC3s (depending on your redundancy, load sharing configuration)
l Torx T10 screwdriver
l Installation Overview — SH12 Shelf
l Installation Overview — SH4R and SH4R-2 Shelves
l Installation Overview — SH1R Shelf
l Infrastructure Modules
l Handling Modules
299 FSP 3000R7 High-Density Subshelf Guide - R17.2 - Issue:B