Adva 3000R7 - Replacing a CEM; Required Tools and Equipment

Replacing a CEM
Before you start any of these procedures, read the entire section for
important information. For complete safety and compliance information,
see PART 6: SAFETY GUIDELINES.
Replacing a CEM
Required Tools and Equipment 408
Replacing a CEM-2 409
Replacing a CEM-3 410
Replacing a CEM-4 412
You can replace a defective CEM while the shelf is in service. We
recommend that you have a spare CEMavailable at all times.
Required Tools and Equipment
l ESD-preventive wrist strap or other personal grounding device
l Suitable grounded surface or a static-dissipative mat
l Appropriate CEM for the HD shelf
o
CEM-2 for SH12
o
CEM-4 for SH4Rand SH4R-2
o
CEM-3 for SH1R
l Torx T10 screwdriver
l Cable extractor tool (if necessary)
l Electrostatic Discharge Damage Prevention and Warning
l Handling Modules
l General Installation and Maintenance Guidelines
FSP 3000R7 High-Density Subshelf Guide - R17.2 - Issue:B 408