Arris C4 - Page 392

Chapter 14: Cable-side Configuration
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 392
Description
Command
This command configures the IP protocol mode
to be used by the cable modems served by this
MAC domain.
Use the [no] option to remove the specified
cable modem IP provisioning
configure interface cable-mac <mac> cable cm-ip-prov-mode
[<apm> | <ipv6only> | <ipv4only>][no]
Example command:
configure interface cable-mac 3 cable cm-ip-prov-mode apm
This command enables cable modem status
event reporting by the cable modems served
by the MAC domain.
Use the [no] option to disable the signaling of
the CM-Status Event reporting mechanism,
configure interface cable-mac <mac> cable cm-status enabled
[no]
Example command:
configure interface cable-mac 3 cable cm-status enabled
This command enables the C4/c CMTS to use IP
Multicast DSID-based Forwarding (MDF) to
cable modems in the MAC domain.
Use the [no] option to disable IP MDF on the
specified cable-mac,
configure interface cable-mac <mac> cable mcast-fwd-by-dsid
[no]
Example command:
configure interface cable-mac 3 cable mcast-fwd-by-dsid
This command configures the interval (in
milliseconds) between successive
transmissions of the MAC domain descriptor
message (MDD) within the MAC domain.
Use the [no] option to remove the insertion
interval.
configure interface cable-mac <mac> cable mdd-interval <int>
[no]
Example command:
configure interface cable-mac 3 cable mdd-interval 150
This command enables the CMs to operate on
multiple downstreams within the MAC domain.
This is called multiple receive channel mode.
Note: Multiple receive channel mode must
be enabled before multiple transmit channel
mode may be enabled.
configure interface cable-mac <mac> cable mult-rx-chl-mode [no]
Example command:
configure interface cable-mac 3 cable mult-rx-chl-mode