Chapter 14: Cable-side Configuration
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 393
Use the [no] option to prevent CMs from
operating on multiple downstreams within the
MAC domain.
This command configures CMs to operate on
multiple upstreams within the MAC domain.
Use the [no] option to disable CMs from
operating on multiple upstreams within the
MAC domain.
configure interface cable-mac <mac> cable mult-tx-chl-mode [no]
Example command:
configure interface cable-mac 3 cable mult-tx-chl-mode
This command configures an override value (in
seconds) for the T6 timer in the CM that runs
while awaiting a response to a registration
request. TheC4/c CMTS also uses this timer
when multiple downstream channel mode is
enabled, but not multiple transmit channel
mode. Use the [no] option to return to the
default setting.
configure interface cable-mac <mac> cable reg-rsp-timer-t6
<time> [no]
Example command:
configure interface cable-mac 3 cable mult-tx-chl-mode
To Next Page
Loading...
