Cisco Nexus 3000 series - Feature Ntp

Send comments to nexus3k-docfeedback@cisco.com
-SM-76
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
feature ntp
feature ntp
To enable the Network Time Protocol (NTP), use the feature ntp command. To disable NTP, use the no
form of this command.
feature ntp
no feature ntp
Syntax Description This command does not have any arguments or keywords.
Defaults Enabled
Command Modes Global configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to enable NTP:
switch# configure terminal
switch(config)# feature ntp
This example shows how to disable NTP:
switch# configure terminal
switch(config)# no feature ntp
Related Commands
Release Modification
6.0(2)U(2)1 This command was introduced.
Command Description
ntp master Configures the device to act as an authoritative NTP server.