Cisco Nexus 3000 series - Ptp Priority1

Send comments to nexus3k-docfeedback@cisco.com
-SM-163
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
ptp priority1
ptp priority1
To configure the priority1 value when advertising the Precision Time Protocol (PTP) clock, use the ptp
priority1 command. To remove the priority1 value, use the no form of this command.
ptp priority1 priority-number
no ptp priority1 priority-number
Syntax Description
Command Default 255
Command Modes Global configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure the priority1 value when advertising the PTP clock:
switch# configure terminal
switch(config)# ptp priority1 10
switch(config)#
This example shows how to remove the priority1 value when advertising the PTP clock:
switch# configure terminal
switch(config)# no ptp priority1 10
switch(config)#
Related Commands
priority-number Priority number. The range is from 0 to 255.
Release Modification
5.0(3)U2(2) This command was introduced.
Command Description
feature ptp Enables or disables PTP on the switch.
ptp source Configures the source IP address for all PTP packets.
ptp domain Configures the domain number to use for this clock.
ptp priority2 Configures the priority2 value to use when advertising this clock.
show ptp brief Displays the PTP status.
show ptp clock Displays the properties of the local clock.