Cisco Nexus 3000 series - Feature Ptp

Send comments to nexus3k-docfeedback@cisco.com
-SM-77
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
feature ptp
feature ptp
To enable the Precision Time Protocol (PTP) feature, use the feature ptp command. To disable the PTP
feature, use the no form of this command.
feature ptp
no feature ptp
Syntax Description This command has no arguments or keywords.
Command Default Disabled
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to enable the PTP feature:
switch# configure terminal
switch(config)# feature ptp
switch(config)#
This example shows how to disable the PTP feature:
switch# configure terminal
switch(config)# no feature ptp
switch(config)#
Related Commands
Release Modification
5.0(3)U2(1) This command was introduced.
Command Description
ptp source Configures the source IP address for all PTP packets.
ptp domain Configures the domain number to use for this clock.
ptp priority1 Configures the priority1 value to use when advertising this clock.
ptp priority2 Configures the priority2 value to use when advertising this clock.