Cisco Nexus 3000 series - Monitor Erspan Origin Ip-Address

Send comments to nexus3k-docfeedback@cisco.com
-SM-119
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
monitor erspan origin ip-address
monitor erspan origin ip-address
To configure the Encapsulated Remote Switched Port Analyzer (ERSPAN) global origin IP address, use
the monitor espan origin ip-address command. To remove the ERSPAN global origin IP address
configuration, use the no form of this command.
monitor erspan origin ip-address ip-address [global]
no monitor erspan origin ip-address ip-address [global]
Syntax Description
Command Default None
Command Modes Global configuration mode
Command History
Usage Guidelines When you change the origin IP address, it impacts all the sessions.
Note On a Cisco Nexus 3000 Series switch, only global origin IP address is supported.
This command does not require a license.
Examples This example shows how to configure the ERSPAN global origin IP address:
switch# configure terminal
switch(config)# monitor erspan origin ip-address 10.1.1.1 global
switch(config)#
This example shows how to remove the ERSPAN global origin IP address:
switch# configure terminal
switch(config)# no monitor erspan origin ip-address 10.1.1.1 global
switch(config)#
Related Commands
ip-address IP address.
global (Optional) Specifies the default global configuration.
Release Modification
5.0(3)U2(2) This command was introduced.
Command Description
monitor session Configures a SPAN or an ERSPAN session.