Cisco Nexus 3000 series - Show Ptp Port

Send comments to nexus3k-docfeedback@cisco.com
-SM-258
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
show ptp port
show ptp port
To display information about the Precision Time Protocol (PTP) port, use the show ptp port command.
show ptp port interface ethernet slot/port
Syntax DescriptionT
Command Default None
Command Modes Any command mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display information about the PTP port on the Ethernet interface 1/5:
switch# show ptp port interface ethernet 1/5
PTP Port Dataset: Eth1/5
Port identity: clock identity: 0: 5:73:ff:ff:ff:5b: 1
Port identity: port number: 4
PTP version: 2
Port state: Disabled
VLAN info: 1
Delay request interval(log mean): 2
Peer mean path delay: 0
Announce interval(log mean): 1
Sync interval(log mean): -2
Delay Mechanism: End to End
Peer delay request interval(log mean): 0
switch#
interface Specifies the interface.
ethernet slot/port Specifies an IEEE 802.3z Ethernet interface. The slot number is from 1 to
255 and the port number is from 1 to 128.
Release Modification
5.0(3)U2(2) This command was introduced.