Cisco Nexus 3000 series - New and Changed Information

15
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
New and Changed Information
This chapter provides release-specific information for each new and changed feature in the Cisco Nexus
3000 Series NX-OS System Management Command Reference. The latest version of this document is
available at the following Cisco website:
http://www.cisco.com/en/US/products/ps11541/tsd_products_support_series_home.html
To check for additional information about this Cisco NX-OS Release, see the Cisco Nexus 3000 Series
Switch Release Notes available at the following Cisco website:
http://www.cisco.com/en/US/products/ps11541/prod_release_notes_list.html
Table 1 summarizes the new and changed features for Cisco NX-OS and tells you where they are
documented.
Table 1 New and Changed Information
Feature Description
Changed in
Release Where Documented
Precision time protocol The sync interval range is now 2 to 4. 7.0(3)I2(1) ptp sync interval
Precision time protocol The announce timeout range is now 2 to 4. 7.0(3)I2(1) ptp announce
Show monitor session The number of TCAM entries available for
ACL SPAN has been reduced by 6 entries.
7.0(3)I2(1) show monitor session
show logging onboard While the induced errors are corrected on the
switches, the log messages that notify the
corrections stop after hitting a threshold
(usually after 15 or 19 corrections). Also, an
extra message gets printed when the parity
error is injected.
7.0(3)I2(1) show logging onboard
Show monitor session The option for filter VLANs has been
removed. This feature now displays rx, tx,
and both for the source VLANs.
7.0(3)I2(1) show monitor session
Snmp-server contact This command no longer has a default name
and must be configured to enable callhome.
7.0(3)I2(1) snmp-server contact