Cisco Nexus 3000 series - Snmp-Server Enable Traps Link

Send comments to nexus3k-docfeedback@cisco.com
-SM-306
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
snmp-server enable traps link
snmp-server enable traps link
To enable the Simple Network Management Protocol (SNMP) notifications on link traps, use the
snmp-server enable traps link command. To disable SNMP notifications on link traps, use the no form
of this command.
snmp-server enable traps link [notification-type]
no snmp-server enable traps link [notification-type]
Syntax Description
Command Default Disabled
Command Modes Global configuration mode
Command History
notification-type (Optional) Type of notification to enable. If no type is specified, all
notifications available on your device are sent. The notification type can be
one of the following keywords:
• IETF-extended-linkDown—Enables the Internet Engineering Task
Force (IETF) extended link state down notification.
• IETF-extended-linkUp—Enables the IETF extended link state up
notification.
• cisco-extended-linkDown—Enables the Cisco extended link state
down notification.
• cisco-extended-linkUp—Enables the Cisco extended link state up
notification.
• connUnitPortStatusChange—Enables the overall status of the
connectivity unit Notification.
• delayed-link-state-change—Enables the delayed link state change.
• fcTrunkIfDownNotify—Enables the Fibre Channel Fabric Element
(FCFE) link state down notification.
• fcTrunkIfUpNotify—Enables the FCFE link state up notification.
• fcot-inserted—Specifies that the Fibre Channel optical transmitter
(FCOT) hardware has been inserted.
• fcot-removed—Specifies that the FCOT has been removed.
• linkDown—Enables the IETF Link state down notification.
• linkUp—Enables the IETF Link state up notification.
Release Modification
5.0(3)U1(1) This command was introduced.