Cisco Nexus 3000 series - Show Running-Config Eem

Send comments to nexus3k-docfeedback@cisco.com
-SM-266
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
show running-config eem
show running-config eem
To display information about running configuration for the Embedded Event Manager (EEM), use the
show running-config eem command.
show running-config eem
Syntax Description This command has no arguments or keywords.
Defaults None
Command Modes Any command mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display information about running configuration for the EEM:
switch # show running-config eem
!Command: show running-config eem
!Time: Thu Feb 23 01:53:06 2012
version 5.0(3)U5(1)
event manager environment emailto "admin@abc.com"
event manager applet default-applet
action 1.1 cli show version
"
action 1.2 counter name count1 value $variable op dec
event manager applet eventcli-applet
event oir fan remove 1
event manager applet monitorShutdown
description "Monitors interface shutdown."
event cli match "shutdown"
action 1.0 cli show interface ethernet 3/1
event manager applet snmp-applet
event snmp oid 4.2.1.6 get-type next entry-op eq entry-val 42 poll-interval 32
1321321
action 1.7 snmp-trap strdata "EEM detected server failure"
event manager applet syslog-applet
action 1.7 syslog priority critical msg cpu usage high
event manager applet test_app
event manager applet tracking-applet
event track 20 state up
switch#
Release Modification
5.0(3)U3(1) This command was introduced.