Cisco Nexus 3000 series - Sflow Agent-Ip

Send comments to nexus3k-docfeedback@cisco.com
-SM-179
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
sflow agent-ip
sflow agent-ip
To configure an IP address to the sFlow Agent, use the sflow agent-ip command. To remove the IP
address, use the no form of this command.
sflow agent-ip ip-address
no sflow agent-ip ip-address
Syntax Description
Defaults None
Command Modes Global configuration
Command History
Usage Guidelines You must specify a valid IP address to enable sFlow functionality.
This command does not require a license.
Examples This example shows how to configure the IPv4 address of the sFlow Agent.
switch(config)# sflow agent-ip 192.0.2.3
switch(config)# copy running-config startup-config
Related Commands
ip-address IPv4 address.
Release Modification
5.0(3)U4(1) This command was introduced.
Command Description
feature sflow Enables sFlow.
show sflow Displays sFlow information.