Cisco Nexus 3000 series - Show Mpls Strip Labels

Send comments to nexus3k-docfeedback@cisco.com
-SM-233
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
show mpls strip labels
show mpls strip labels
To display the MPLS label configuration, use the show mpls strip labels command.
show mpls strip labels [label | all | dynamic | static]
Syntax Description
Command Default All labels are displayed.
Command Modes EXEC mode
Command History
Examples This example shows how to display all MPLS labels:
switch(config)# show mpls strip labels
MPLS Strip Labels:
Total : 3005
Static : 5
Legend: * - Static Label
Interface - where label was first learned
Idle-Age - Seconds since last use
SW-Counter- Packets received in Software
HW-Counter- Packets switched in
Hardware--------------------------------------------------------------------------------
Label Interface Idle-Age SW-Counter HW-Counter
--------------------------------------------------------------------------------
4096 Eth1/53/1 15 1 210
4097 Eth1/53/1 15 1 210
4098 Eth1/53/1 15 1 210
4099 Eth1/53/1 7 2 219
4100 Eth1/53/1 7 2 219
4101 Eth1/53/1 7 2 219
4102 Eth1/53/1 39 1 206
4103 Eth1/53/1 39 1 206
4104 Eth1/53/1 39 1 206
4105 Eth1/53/1 1 1 217
4106 Eth1/53/1 1 1 217
4107 Eth1/53/1 1 1 217
4108 Eth1/53/1 15 1 210
* 25000 None <User> 39 1 206
* 20000 None <User> 39 1 206
* 21000 None <User> 1 1 217
label Specifies the label to be displayed.
all Specifies that all labels must be displayed. This is the default option.
dynamic Specifies that only dynamic labels must be displayed.
static Specifies that only static labels must be displayed.
Release Modification
6.0(2)U2(5) This command was introduced.