Cisco Nexus 3000 series - Rmon Event

Send comments to nexus3k-docfeedback@cisco.com
-SM-173
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
rmon event
rmon event
To configure Remote Monitoring (RMON) events to associate with RMON alarms, use the rmon event
command. To remove an RMON event, use the no form of this command.
rmon event event-index [description string] [log] [trap] [owner name]
no rmon event event-index [description string] [log] [trap] [owner name]
Syntax Description
Command Default None
Command Modes Global configuration mode
Command History
Usage Guidelines Before you use this command, you must have configured an SNMP user and enabled SNMP notifications
using the snmp-server user and snmp-server enable traps command, respectively.
You can reuse the same event with multiple RMON alarms.
Examples This example shows how to configure an RMON event:
switch# configure terminal
switch(config)# rmon event 1 owner test
switch(config)#
Related Commands
event-index Event or action that the switch takes when an alarm, rising or falling,
triggers. The event index range is from 0 to 65535.
description string (Optional) Specifies a description for the event. The description can be any
alphanumeric string.
log (Optional) Specifies that an RMON log be generated when the event occurs.
trap (Optional) Specifies that an SNMP trap be generated when the event occurs.
owner name (Optional) Specifies an owner for the alarm. The name can be any
alphanumeric string.
Release Modification
5.0(3)U1(1) This command was introduced.
Command Description
copy running-config
startup-config
Saves the running configuration to the startup configuration file.
snmp-server enable
traps
Enables SNMP notifications on the switch.