Cisco Nexus 3000 series - Show Ntp Status

Send comments to nexus3k-docfeedback@cisco.com
-SM-248
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
show ntp status
show ntp status
To display the Network Time Protocol (NTP) distribution status, use the show ntp status command.
show ntp status
Syntax Description This command has no arguments or keywords.
Defaults Disabled
Command Modes Any command mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display the distribution status for NTP.
switch(config)# show ntp status
Distribution : Enabled
Last operational state: No session
Release Modification
6.0(2)U(2)1 This command was introduced.