Cisco Nexus 3000 series - Logging Module

Send comments to nexus3k-docfeedback@cisco.com
-SM-111
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
logging module
logging module
To enable module log messages, use the logging module command. To disable module log messages,
use the no form of this command.
logging module [severity-level]
no logging module
Syntax Description
Command Default None
Command Modes Global configuration mode
Command History
Usage Guidelines Set a specified severity level or use the default.
Examples This example shows how to enable module log messages:
switch# configure terminal
switch(config)# logging module
switch(config)#
Related Commands
severity-level (Optional) Number of the desired severity level at which messages should be
logged. Messages at or numerically lower than the specified level are logged.
Severity levels are as follows:
• 0—emergency: System unusable
• 1—alert: Immediate action needed
• 2—critical: Critical condition
• 3—error: Error condition
• 4—warning: Warning condition
• 5—notification: Normal but significant condition—default level
• 6—informational: Informational message only
• 7—debugging: Appears during debugging only
Release Modification
5.0(3)U1(1) This command was introduced.
Command Description
show logging module Displays the module logging status.