Cisco Nexus 3000 series - Show Running-Config Interface

Send comments to nexus3k-docfeedback@cisco.com
-SM-270
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
show running-config interface
show running-config interface
To display the running configuration information for interfaces, use the show running-config interface
command.
show running-config interface [all | ethernet slot/port | loopback if_number | mgmt mgmt_intf |
port-channel po_number]
Syntax Description
Command Default Displays only the configured information.
Command Modes EXEC mode
Command History
Examples This example shows how to display the running configuration for a specified Ethernet interface on a
switch that runs Cisco NX-OS Release 5.0(3)U2(1):
switch# show running-config interface ethernet 1/5
!Command: show running-config interface Ethernet1/5
!Time: Fri Aug 26 04:12:01 2011
version 5.0(3)U2(1)
interface Ethernet1/5
speed auto
switch#
Related Commands
all (Optional) Displays all the default and configured information.
ethernet slot/port Specifies the Ethernet interface and the slot number and port number. The
slot number is from 1 to 255, and the port number is from 1 to 128.
loopback if_number Specifies the loopback interface. The loopback interface number is from 0
to 1023.
mgmt mgmt_intf Specifies the management interface. The interface number is 0.
port-channel number Specifies the EtherChannel interface and EtherChannel number. The range
is from 1 to 4096.
Release Modification
5.0(3)U1(1) This command was introduced.
Command Description
copy running-config
startup-config
Copies the running configuration information to the startup configuration
file.