Cisco Nexus 3000 series - Event Sysmgr

Send comments to nexus3k-docfeedback@cisco.com
-SM-72
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
event sysmgr
event sysmgr
To specify an event criteria for an Embedded Event Manager (EEM) applet that is run on the basis of the
system manager event, use the event sysmr command. To remove the system manager event criteria, use
the no form of this command.
event sysmgr [memory [major major-percent minor minor-percent clear clear-percent | module
module-number] | switchover count count time time-interval]
no event symgr
Syntax Description
Defaults None
Command Modes Embedded event manager configuration mode
Command History
Usage Guidelines This command does not require a license.
memory (Optional) Specifies the memory alert event.
major
major-percent
(Optional) Sets the major memory threshold. The range is from 1 to 99.
minor
minor-percent
(Optional) Sets the minor memory threshold. The range is from 1 to 99.
clear clear-percent (Optional) Sets the percentage of memory that needs to be cleared. The range is
from 1 to 99.
module
module-number
(Optional) Specifies the module number. The module number range is from 1 to 1.
switchover (Optional) Specifies the switchover-related events.
count count (Optional) Specifies the number of switchovers after which the event should be
triggered. The range is from 1 to 65000.
time time-interval (Optional) Specifies the time interval within which the events need to happen.
The range is from 1 to 4294967295.
Release Modification
5.0(3)U3(1) This command was introduced.