Cisco Nexus 3000 series - Event Cli

Send comments to nexus3k-docfeedback@cisco.com
-SM-54
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
event cli
event cli
To specify the event criteria for an Embedded Event Manager configuration mode(EEM) applet that is
run by matching a Cisco NX-OS command-line interface (CLI) command, use the event cli command.
To remove the CLI command event criteria, use the no form of this command.
event cli [tag tag] match regex [count count-number]
no event cli match regex [count count-number]
Syntax Description
Defaults None
Command Modes Embedded event manager configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to specify a CLI command for the EEM applet to match:
switch# configure terminal
switch(config)# event manager applet eventcli-applet
switch(config-applet)# event cli match "shutdown” count 10
switch(config-applet)#
tag tag (Optional) Identifies this specific event when multiple events are included in the
policy. The tag name can be any alphanumeric string up to 29 characters.
match regex Specifies the regular expression (regex) used to perform the CLI command
pattern match. The regex can be up to 512 characters. Use * to wildcard a token.
count
count-number
(Optional) Specifies the number of matching occurrences before an EEM event is
triggered. The count-number must be an integer that is greater than 0.
Release Modification
5.0(3)U3(1) This command was introduced.