Cisco Nexus 3000 series - Logging Monitor

Send comments to nexus3k-docfeedback@cisco.com
-SM-112
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
logging monitor
logging monitor
To enable the device to log messages to the monitor (terminal line), use the logging monitor command.
To disable monitor log messages, use the no form of this command.
logging monitor [severity-level]
no logging monitor
Syntax Description
Command Default None
Command Modes Global configuration mode
Command History
Usage Guidelines This configuration applies to Telnet and Secure Shell (SSH) sessions.
Examples This example shows how to enable monitor log messages:
switch# configure terminal
switch(config)# logging monitor
switch(config)#
Related Commands
severity-level (Optional) Number of the desired severity level at which messages should be
logged. Messages at or numerically lower than the specified level are logged.
Severity levels are as follows:
• 0—emergency: System unusable
• 1—alert: Immediate action needed
• 2—critical: Critical condition—default level
• 3—error: Error condition
• 4—warning: Warning condition
• 5—notification: Normal but significant condition
• 6—informational: Informational message only
• 7—debugging: Appears during debugging only
Release Modification
5.0(3)U1(1) This command was introduced.
Command Description
show logging monitor Displays the status of monitor logging.