Cisco Nexus 3000 series - Ptp Priority2

Send comments to nexus3k-docfeedback@cisco.com
-SM-164
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
ptp priority2
ptp priority2
To configure the priority2 value when advertising the Precision Time Protocol (PTP) clock, use the ptp
priority2 command. To remove the priority2 value when advertising the PTP, use the no form of this
command.
ptp priority2 priority-number
no ptp priority2 priority-number
Syntax Description
Command Default 255
Command Modes Global configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure the priority2 value when advertising the PTP clock:
switch# configure terminal
switch(config)# ptp priority2 1
switch(config)#
This example shows how to remove the priority2 value configuration for use when advertising the PTP
clock:
switch# configure terminal
switch(config)# no ptp priority2 1
switch(config)#
Related Commands
priority-number Priority number. The range is from 0 to 255.
Release Modification
5.0(3)U2(2) This command was introduced.
Command Description
feature ptp Enables or disables PTP on the device.
ptp source Configures the source IP address for all PTP packets.
ptp domain Configures the domain number to use for this clock.
ptp priority1 Configures the priority1 value to use when advertising this clock.
show ptp brief Displays the PTP status.
show ptp clock Displays the properties of the local clock.