Cisco Nexus 3000 series - Source Ip (ERSPAN)

Send comments to nexus3k-docfeedback@cisco.com
-SM-322
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
source ip (ERSPAN)
source ip (ERSPAN)
To configure the source IP address for an an Encapsulated Remote Switched Port Analyzer (ERSPAN)
destination, use the source ip command. To remove the source IP configuration, use the no form of this
command.
source ip ip_address
no source ip ip_address
Syntax Description
Command Default None
Command Modes ERSPAN destination configuration mode
Command History
Usage Guidelines An ERSPAN destination session supports only one source IP address.
Examples This example shows how to configure a source IP address for an ERSPAN session:
switch# configure terminal
switch(config)# monitor session 1 type erspan-destination
switch(config-erspan-dst)# source ip 192.0.2.1
switch(config-erspan-dst)#
Related Commands
ip_address IP address for the ERSPAN session.
Release Modification
5.0(3)U2(2) This command was introduced.
Command Description
monitor session Creates a new SPAN session configuration.
show monitor session Displays SPAN session configuration information.
show running-config
monitor
Displays the running configuration information of a SPAN session.