Cisco Nexus 3000 series - Show Rmon

Send comments to nexus3k-docfeedback@cisco.com
-SM-261
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
show rmon
show rmon
To display information about Remote Monitoring (RMON) alarms or high-capacity alarms or events, use
the show rmon command.
show rmon {alarms | events | hcalarms | info | logs}
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display the RMON high-capacity alarms configured on the switch:
switch# show rmon hclarms
High Capacity Alarm 3 is active, owned by admin
Monitors 1.3.6.1.2.1.2.2.1.17.83886080 every 5 second(s)
Taking delta samples, last value was 216340
Rising threshold is 0, assigned to event 3
Falling threshold is 0, assigned to event 0
On startup enable rising alarm
Number of Failed Attempts is 0
switch#
This example shows how to display the RMON events configured on the switch:
switch# show rmon events
Event 5 is active, owned by admin
Description is myRMONEvent
Event firing causes nothing, last fired never
switch#
This example shows how to display the RMON configuration information:
switch# show rmon info
Maximum allowed 32 bit or 64 bit alarms : 512
Number of 32 bit alarms configured : 0
Number of 64 bit hcalarms configured : 1
switch#
alarms Displays the RMON alarms.
events Displays the RMON events.
hcalarms Displays the RMON high-capacity alarms.
info Displays the RMON configuration information.
logs Displays information about the RMON event logs.
Release Modification
5.0(3)U1(1) This command was introduced.