Cisco Nexus 3000 series - Enable (Call Home)

Send comments to nexus3k-docfeedback@cisco.com
-SM-52
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
enable (Call Home)
enable (Call Home)
To enable the Cisco Smart Call Home service after you have configured the contact information, use the
enable command. To disable the Smart Call Home service, use the no form of this command.
enable
no enable
Syntax Description This command has no arguments or keywords.
Command Default Disabled
Command Modes Callhome configuration mode
Command History
Usage Guidelines You must configure an e-mail server. Your switch must have IP connectivity to an e-mail server. You
must configure the contact name (SNMP server contact), phone, and street address information before
you enable Call Home.
Examples This example shows how to enable the Cisco Smart Call Home service:
switch# configure terminal
switch(config)# callhome
switch(config-callhome)# enable
contact email address is not configured
callhome can not be enabled on the switch, because necessary configuration has not been
done
Please check if all of following configuration is done
contact person name(sysContact)
contact person's email
contact person's phone number
street addr
To configure sysContact, please use snmp-server command
switch(config-callhome)#
This example shows how to disable the Cisco Smart Call Home service:
switch# configure terminal
switch(config)# callhome
switch(config-callhome)# no enable
switch(config-callhome)#
Release Modification
5.0(3)U1(1) This command was introduced.