Cisco Nexus 3000 series - Diagnostic Bootup Level

Send comments to nexus3k-docfeedback@cisco.com
-SM-49
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
diagnostic bootup level
diagnostic bootup level
To configure the bootup diagnostic level to trigger diagnostics when the device boots, use the diagnostic
bootup level command. To remove bootup diagnostic level configuration, use the no form of this
command.
diagnostic bootup level {bypass | complete}
no diagnostic bootup level {bypass | complete}
Syntax Description
Command Default Complete
Command Modes Global configuration mode
Command History
Examples This example shows how to configure the bootup diagnostics level to trigger the complete diagnostics:
switch# configure terminal
switch(config)# diagnostic bootup level complete
switch(config)#
This example shows how to remove the bootup diagnostics level configuration:
switch# configure terminal
switch(config)# no diagnostic bootup level complete
switch(config)#
Related Commands
bypass Specifies that all bootup tests are skipped.
complete Specifies that all bootup diagnostics are performed. This is the default
value.
Release Modification
5.0(3)U1(1) This command was introduced.
Command Description
show diagnostic
bootup level
Displays the bootup diagnostics level.
show diagnostic
bootup result
Displays the results of the diagnostics tests.