Cisco Nexus 3000 series - Event Oir

Send comments to nexus3k-docfeedback@cisco.com
-SM-64
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
event oir
event oir
To specify an event criteria for an Embedded Event Manager (EEM) applet that is run on the basis of an
Online-Insertion-Removal (OIR), use the event oir command. To remove the OIR event criteria, use the
no form of this command.
event oir {fan [anyoir | insert | remove] | module [anyoir | insert | remove] | powersupply [anyoir
| insert | remove] | tag tag}
no event oir {fan [anyoir | insert | remove] | module [anyoir | insert | remove] | powersupply
[anyoir | insert | remove] | tag tag}
Syntax Description
Defaults None
Command Modes Embedded event manager configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to specify that an EEM applet runs when an OIR occurs:
switch# configure terminal
switch(config) event manager applet cli-event
switch(config-applet)# event oir fan remove 1
switch(config-applet)#
fan Specifies a fan OIR event.
anyoir (Optional) Specifies any OIR event.
insert (Optional) Specifies the OIR insert event.
remove (Optional) Specifies the OIR remove event.
module Specifies the module OIR event.
powersupply Specifies a power supply OIR event.
tag tag Identifies this specific event when multiple events are included in the policy. The
tag name can be any alphanumeric string up to 29 characters.
Release Modification
5.0(3)U3(1) This command was introduced.