Cisco Nexus 3000 series - Snmp-Server Contact

Send comments to nexus3k-docfeedback@cisco.com
-SM-300
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
snmp-server contact
snmp-server contact
To configure the Simple Network Management Protocol (SNMP) contact (sysContact) information, use
the snmp-server contact command. To remove the contact information, use the no form of this
command.
Note Beginning with release 7.0(3)I2(1), snmp-server contact no longer has a default name and must
be configured to enable callhome.
snmp-server contact [text]
no snmp-server contact [text]
Syntax Description
Command Default No system contact (sysContact) string is set.
Command Modes Global configuration mode
Command History
Examples This example shows how to set an SNMP contact:
switch# configure terminal
switch(config)# snmp-server contact DialSystemOperatorAtBeeper#1235
switch(config)#
This example shows how to remove an SNMP contact:
switch# configure terminal
switch(config)# no snmp-server contact DialSystemOperatorAtBeeper#1235
switch(config)#
Related Commands
text (Optional) String that describes the system contact information. The text
can be any alphanumeric string up to 32 characters and cannot contain
spaces.
Release Modification
5.0(3)U1(1) This command was introduced.
7.0(3)I2(1) This command no longer has a default name and must be configured to
enable callhome.
Command Description
show snmp Displays information about SNMP.
snmp-server location Sets the system location string.