Cisco Nexus 3000 series - Ntp Logging

Send comments to nexus3k-docfeedback@cisco.com
-SM-140
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
ntp logging
ntp logging
To enable Network Time Protocol (NTP) logging, use the ntp logging command. To disable NTP
logging, use the no form of this command.
ntp logging
no ntp logging
Syntax Description This command has arguments or keywords.
Defaults Disabled
Command Modes Global configuration mode (config)
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to enable NTP logging:
switch# configure terminal
switch(config)# ntp logging
switch(config)#
This example shows how to disable NTP logging:
switch# configure terminal
switch(config)# no ntp logging
switch(config)#
Release Modification
6.0(2)U(2)1 This command was introduced.