Cisco Nexus 3000 series - Show Diagnostic Result

Send comments to nexus3k-docfeedback@cisco.com
-SM-194
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
show diagnostic result
show diagnostic result
To display the results of the diagnostic tests, use the show diagnostic result command.
show diagnostic result module {module-no | all}
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display the diagnostic results for a specific module:
switch# show diagnostic result module 1
Related Commands
module Specifies the module for which diagnostic results are displayed.
module-no Module number. Valid values are 1 to 3.
all Displays the diagnostic results for all modules.
Release Modification
5.0(3)U1(1) This command was introduced.
Command Description
diagnostic bootup level Configures the bootup diagnostic level for a faster module bootup time.
show diagnostic
bootup level
Displays the bootup diagnostics level.