Cisco Nexus 3000 series - Ip Port Access-Group (Session)

Send comments to nexus3k-docfeedback@cisco.com
-SM-97
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
ip port access-group (session)
ip port access-group (session)
To apply an IPv4 access control list (ACL) to an interface as a port ACL, use the ip port access-group
command. To remove an IPv4 ACL from an interface, use the no form of this command.
ip port access-group access-list-name {in | out}
no ip port access-group access-list-name {in | out}
Syntax Description
Command Default None
Command Modes Session interface configuration mode
Command History
Examples This example shows how to apply an IPv4 ACL named ip-acl-01 to the Ethernet interface 1/2 as a port
ACL:
switch# configure session MySession1
switch(config-s)# interface ethernet 1/2
switch(config-s-if)# ip port access-group ip-acl-01 in
switch(config-s-if)#
This example shows how to remove an IPv4 ACL named ip-acl-01 from Ethernet interface 1/2:
switch(config-s)# interface ethernet 1/2
switch(config-s-if)# no ip port access-group ip-acl-01 in
switch(config-s-if)#
Related Commands
access-list-name Name of the IPv4 ACL. The name can be up to 64 alphanumeric,
case-sensitive characters.
in Specifies that the ACL applies to inbound traffic.
out Specifies that the ACL applies to outbound traffic.
Release Modification
5.0(3)U1(1) This command was introduced.
Command Description
show access-lists Displays all ACLs.
show configuration
session
Displays the contents of the session.