Cisco Nexus 3000 series - Sflow Collector-Port

Send comments to nexus3k-docfeedback@cisco.com
-SM-181
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
sflow collector-port
sflow collector-port
To configure a destination port for the sFlow datagram, use the sflow collector-port command. To
remove the destination port, use the no form of this command.
sflow collector-port collector-port
no sflow collector-port collector-port
Syntax Description
Defaults None
Command Modes Global configuration
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure the destination port for the sFlow datagrams.
switch# configure terminal
switch(config)# sflow collector-port 7000
switch(config)# copy running-config startup-config
[########################################] 100%
switch(config)#
Related Commands
collector-port UDP port of the sFlow analyzer. The range for the collector-port is from
0 to 65535. The default value is 6343.
Release Modification
5.0(3)U4(1) This command was introduced.
Command Description
feature sflow Enables sFlow.
show sflow Displays sFlow information.