Cisco Nexus 3000 series - Event Policy-Default

Send comments to nexus3k-docfeedback@cisco.com
-SM-65
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
event policy-default
event policy-default
To configure an event in case a system policy is being overridden, use the event policy-default
command. To use the overridden policy, use the no form of this command.
event policy-default count count time seconds
no event policy-default count count time seconds
Syntax Description
Defaults None
Command Modes Embedded event manager configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure an event in case a system policy is being overridden:
switch# configure terminal
switch(config) event manager applet cli-event
switch(config-applet)# event policy-default count 15 time 1500
switch(config-applet)#
count count Specifies the number of matching occurrences before a default event is triggered.
The range is from 1 to 65000.
time seconds Specifies the interval in seconds, within which the events need to happen. The
range is from 0 to 4294967295.
Release Modification
5.0(3)U3(1) This command was introduced.